Results 1 to 2 of 2

Thread: well point

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Newbie
    Join Date
    Feb 2009
    Location
    Florida, USA.
    Posts
    1

    well point

    I am planning to make a irrigation system, install a well and pump with 3 zones to use 6 to 8 gpm each zone. I have a 3/4 hp grundfos shallow well Jet pump with pressure switch, given to me that i would like to use. The pump had been hooked up with a tank before. The water table is 15 to 20 feet pure sand. I would like to use a well point.
    Should I jet down pvc or bang down steel. what is the gpm I can expect from each in good water conditions
    Do i have to use a tank with this pump, if not how do I hook it up without a tank

  2. #2
    Pump guy speedbump's Avatar
    Join Date
    Jun 2005
    Location
    Murphy, NC. USA.
    Posts
    11,785
    I can't tell you what is the best method because it varies all over the State. Here I have seen both kinds of wells done. Some washed in others banged in. Once you do get into water, I would expect 5 to 15 gallons per minute on average with a screen or point. There is a lot of difference in well points. Big Box stores sell the worst.

    I don't know if your Grundfos 3/4hp is going to give you the eight gallons per minute your looking for at the pressure you will need.

    A tank is not necessary unless you want to hand water on demand or wash the car/dog.

    bob...

    Products and Pricing

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •