Results 1 to 3 of 3

Thread: Testing Franklin Control Box

  1. #1

    Testing Franklin Control Box

    My submersible well pump suddenly stopped working. It pressure switch is fine, and there is power being sent to the Franklin Control box. It is the model with a starting capacitor and some other small relay or capacitor on the cover. When the cover is put in place, there are connector prongs that connect to the bus where the power input and out put are attached.

    How can I tell if the capacitors in the control box are the problem or if my well pump (4" well, pump at 60', probably 1 HP)is fried or something? How does one diagnose this?

  2. #2
    Senior Member
    Join Date
    Jun 2005
    Location
    Wherever we park the motorhome, , USA.
    Posts
    569
    www.franklinelectric.com. Then 4" residential troubleshooting etc..


    Gary
    Quality Water Associates
    www.qualitywaterassociates.com
    Softener Forum

  3. #3
    Pump guy speedbump's Avatar
    Join Date
    Jun 2005
    Location
    Murphy, NC. USA.
    Posts
    11,735
    You will need at least a volt/ohm meter. An amp meter would be helpful also.

    bob...

    Products and Pricing

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •