Results 31 to 40 of 43

Thread: Installing a float switch on my system.

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Experienced Newbie
    Join Date
    Jan 2017
    Location
    Battambang, Cambodia
    Posts
    57

    Question Installing a float switch on my system.

    Howdy all,

    I am finally getting around to installing a float switch (low water level cut off) for my pump.

    Basically, I just want to make sure the pump cuts off before the water level drops too far in the poly tank, so as not to cause any damage to the pump.

    2018-06-13 18.12.47_r.jpg s-l500.jpg

    I do not wish to drill any holes in the tank. And, I have 2 each, 3/4" pipe threaded holes on opposite sides of the top of the tank. I am going to drill a hole in a plastic pipe plug, just large enough to thread the float switch cable through it, and into the tank.

    ''_threaded_plug.jpg
    Then, I will seal it with a bit of silicon.

    Am I correct in thinking I only need to break the connection on the hot side of the two-conductor cable coming into the pump, and wire the float switch in series?

    I have already determined which pair (of the three wires) attached to the float switch, that I need to connect, so it will break the circuit when the tank reaches the preset "low" water level.


    NOTE: I initially thought about using a piggy back plug, since the pump is just connected to a power point on the wall of the house. But, later I just decided it best to wire the float switch directly to the hot side of the mains power to the pump.
    Last edited by Asia-Off-Grid; 09-22-2018 at 07:30 AM.
    Paul

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (1 members and 1 guests)

  1. Texas Wellman

Similar Threads

  1. Float Ball Switch combined with a Pressure Switch?
    By pconnolly5 in forum Pumps in general
    Replies: 1
    Last Post: 05-24-2013, 05:41 PM
  2. wiring a float switch to a pressure switch
    By Puerto Rico Gringo in forum Electrical wiring and components
    Replies: 2
    Last Post: 03-26-2012, 12:28 PM
  3. Need New Float Switch in Cistern.
    By BBQDad in forum Electrical wiring and components
    Replies: 7
    Last Post: 09-16-2009, 09:15 AM
  4. Float switch
    By supersport in forum Sprinkler and Irrigation systems.
    Replies: 4
    Last Post: 07-30-2008, 11:25 AM
  5. float switch..
    By David55 in forum Pumps in general
    Replies: 4
    Last Post: 04-25-2006, 07:31 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •